Thingiverse
Mosfet mounting Bracket
von ER05ONE
8
Downloads
8
Likes
0
Makes
Mosfet Mounting Bracket
This is fixed to an Anet A6 - it's a fairly tight fit - as there's not that much room
Drill 3.5 mm (Which is clearance for M3, 9/64 for imperial folks). Use M3 screw and nuts to fasten. (or Glue)
Hole centers:42mm x 52mm
This is fixed to an Anet A6 - it's a fairly tight fit - as there's not that much room
Drill 3.5 mm (Which is clearance for M3, 9/64 for imperial folks). Use M3 screw and nuts to fasten. (or Glue)
Hole centers:42mm x 52mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!