Thingiverse
Mostly Printed Soldering Iron Stand
von Satchel17
0
Downloads
1
Likes
0
Makes
Mostly printed soldering iron stand
used a piece of 3/4in EMT or 23.5 OD pipe 3.5 in long or 8.9cm printed on a stock ender 3 with .4 nozzle, .2mm layer height at 60 mm/s in PLA+ by inland
don't leave on for more than 30m at a time as the part will eventually melt
used a piece of 3/4in EMT or 23.5 OD pipe 3.5 in long or 8.9cm printed on a stock ender 3 with .4 nozzle, .2mm layer height at 60 mm/s in PLA+ by inland
don't leave on for more than 30m at a time as the part will eventually melt
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
