Thingiverse
Mount clip
von Azkali
1
Downloads
1
Likes
0
Makes
Simple mount clip.
### Materials Needed
Adhesive Neoprene foam 1.5mm
### Usage
Three versions of the clip exist, a single, a dual one, a dual one with a leg.
The mount is design for a 7mm screen, you can add neoprene to offset the gap.
Just stick some adhesive (or glue if it is not adhesive) neoprene foam on the inner parts of the mount.
WARNING: Particles can stick to the neoprene foam and are hard to clean, this can result into scratches on your screen if you're not careful.
### Materials Needed
Adhesive Neoprene foam 1.5mm
### Usage
Three versions of the clip exist, a single, a dual one, a dual one with a leg.
The mount is design for a 7mm screen, you can add neoprene to offset the gap.
Just stick some adhesive (or glue if it is not adhesive) neoprene foam on the inner parts of the mount.
WARNING: Particles can stick to the neoprene foam and are hard to clean, this can result into scratches on your screen if you're not careful.
Azkali veröffentlicht auch auf
7 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
