Mount for Autolevel-Sensor (Work In Progress)

This mount should allow to mount the magnetic base to the BantaMount (thing:3543121).

Designed with TINKERCAD.

UPDATE:
=========

I had this working since i designed it. Its stable enough to provide reliable results, as tested with marlin probe accuacy.

The main problem is that its not compatible with the stock firmware.
(I havent tested but offsets are big and you can only set z-offset)

Also on the right side you cant home without it crashing the bed.

In marlin you can easily adjust the probe offset, here are mine:
define X_PROBE_OFFSET_FROM_EXTRUDER 20 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER -13 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER -25 // Z offset: -below +above [the nozzle]

How you configure Mesh-Bed-leveling is up to you. I will post my config below.

My Mesh Creation:
G28 #Home
G0 z50# Lift head a little bit
G0 x200 y200 #Move to middle of the bed, attach probe
G2