Mount for Supernight PSU

This was primarily designed to be used for Solidoodle printers, but if it will fit, please feel free to try it and give a "Made".
This is by far the easiest and cheapest mounting option for the Supernight I have tried. Once printed, line up the Bottom portion to ensure it is straight, and make three mount holes in the frame with a pencil. Drill out the three holes to accept M3 screws, then slide the PSU into the cradle. Please the Top part over your desired location, but do not cover the venting slits to allow proper cooling of the unit. Mark the two mounting holes as you did with the lower, remove the Supernight, and drill the holes for the Top. After the top is locked in the secured, you can now drop in the PSU. Installation is now complete!

Hardware needed:
*5 M3x12mm socket cap screws. M3x16mm should work as well.
*5 M3 nuts