MakerWorld
Hueforge & Lithophane
Go to Model
Mount Rushmore HueForge Picture
8
Downloads
4
Likes
2
Makes
Project: Mount Rushmore STL.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 140x140mm in sizeYou may print at higher layer heights below the Min Depth of 0.72mmThe Max Depth is 2.3mm and the Actual Depth is 1.8mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 2.9 PLA BambuLab Matte Ash Gray Transmission Distance: 1.5 PLA+ Sunlu White Transmission Distance: 5 PLA+ Sunlu Sky Blue Transmission Distance: 4This print uses 5 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Blue Gray At layer #13 (1.12mm) swap to Ash Gray At layer #15 (1.28mm) swap to White At layer #17 (1.44mm) swap to Sky Blue for the rest.**At pause switch Black to Sky BlueBoost MePlease consider sending me a boost! :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
