Thingiverse
Mountable Can/Bottle Holder
von OldManBOMBIN
2
Downloads
1
Likes
0
Makes
Designed to mount on my fourwheeler fender; no IRL photos as I've replaced it with a phone holder. Last printed in PLA; no supports.
Will hold a soda can or bottle of water. Added a top piece to help stabilize water bottles over rough terrain, but it's not really needed unless you're hotdoggin' too hard.
If you print the top piece, use at least 30% infill to help keep the legs intact.
I used it for several weeks with no issue, but my son accidentally snapped one leg in half when riding with no bottle in the holder. Not sure how it happened. He was probably hotdoggin' too hard while dehydrated.
If I reprint this, I intend to try TPU for the top to further prevent snappage.
Will hold a soda can or bottle of water. Added a top piece to help stabilize water bottles over rough terrain, but it's not really needed unless you're hotdoggin' too hard.
If you print the top piece, use at least 30% infill to help keep the legs intact.
I used it for several weeks with no issue, but my son accidentally snapped one leg in half when riding with no bottle in the holder. Not sure how it happened. He was probably hotdoggin' too hard while dehydrated.
If I reprint this, I intend to try TPU for the top to further prevent snappage.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!