Thingiverse
Mountain Bike Pump Holder
16
Downloads
15
Likes
0
Makes
This is a holder for MTB tyre pump.
It holds a 25mm of diameter pump and it fits on a tube with ~34mm of diameter.
It is attached to the bike by some plastic zip-ties and the pump is secured with some velcro strips (10mm wide)
Printing:
PLA, 0.2 layer with 10-15% infill
It holds a 25mm of diameter pump and it fits on a tube with ~34mm of diameter.
It is attached to the bike by some plastic zip-ties and the pump is secured with some velcro strips (10mm wide)
Printing:
PLA, 0.2 layer with 10-15% infill
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
