Mountain Lion Skull

Please enjoy this model. I found it on Thingiverse. However he advised splitting the model to print and then glue it together. I have taken the time to arrange support and a flat area to print on the rear of the skull. There are support blockers where no support is needed but other than that the auto option did a good job with some minor tweaks. The supports all come off easy. Make sure Brim is enables for the rear of the skull on the bed 10mm is safe for the full size print. I printed this using https://www.amazon.com/Filament-Printing-Material-Stronger-CC3D/dp/B099MT5XSTI printed using the eSun PLA+ preset with a few minor speed modifications and I also ran the calibration prints in Bambu studio before printing.The two pieces fit together very nicely and can remain seperate or bonded using simple plastic glue. Please feel free to ask any questions if needed. The model was scanned by the member on Thingiverse, using a skull provided by Idaho Fish and Game. The model was damaged and di