Mounting bracket for Display-Set LS-8

Minimalist display brackets to mount the driver PCB to the display panel in order to prevent the flat flex cable from ripping out accidently and damaging any components (happened to me :-().

__Note:__ this bracket is designed for the [8" HDMI/DVI/VGA/CVBS LCD display from Pollin electronic](http://www.pollin.de/shop/dt/MDQ5ODc4OTk-/Bauelemente_Bauteile/Aktive_Bauelemente/Displays/Display_Set_LS_8_20_3_cm_8_HDMI_DVI_VGA_CVBS.html)!

__Print instructions:__ print the bracket laying on the side to prevent overhang area and filament rippling. You need to print the bracket twice. Use an M3 tap to create a thread in the holes (2.5 mm in diameter).

__Important/TODO:__ the little holder-hook-thingies which hold on to the LCD need to fit snugly but not too tight since this could damage the module. I tweaked the fit with a knife. @TODO: maybe enlarging the width of the hooks (=larger surface) results in the pressure distributed more equally resulting in reducing the mechanical stress.