Thingiverse
Mouse Bait Station
door newton1171
21
Downloads
18
Likes
0
Makes
It's autumn and the mice are heading back inside. Time to give them a treat. This mouse bait station will hold bait up to 30x30x60mm.
I print with supports only on the hooks that snap the top to the bottom. The rest of the overhangs print fine enough for me, but YMMV. To remove the top I find it best to press on one side, then only a slight amount of pressure to release the other side.
I print with supports only on the hooks that snap the top to the bottom. The rest of the overhangs print fine enough for me, but YMMV. To remove the top I find it best to press on one side, then only a slight amount of pressure to release the other side.
newton1171 publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
