Thingiverse
Mouse Bungee v2.0
por jackjt8
11
Descargas
17
Likes
1
Makes
I wanted a mouse bungee for a while now and I wasn't too happy with some of the past designs. So I took it upon myself to design my own.
Learning from the limitations and issues with my first variant, this second version addresses some of the issues that I ran into, such as: The arm has been flattened so there are no overhangs, the base center of mass has been lowered and the bases has been widened, the pin piece used in v1.0 has been removed as it's not needed. Hopefully these changes improve the overall usability of the bungee.
v2 has not been printed yet.
Parts to print:
MCH_v2_base.stl -- (100x100x~10*)mm; *legs 3mm, with ~10mm max for middle
MCH_v2_arm.stl -- (10x110x2.5)mm
Full Print:
MCH_v2_full.stl
MCH_v2.0.scad
Learning from the limitations and issues with my first variant, this second version addresses some of the issues that I ran into, such as: The arm has been flattened so there are no overhangs, the base center of mass has been lowered and the bases has been widened, the pin piece used in v1.0 has been removed as it's not needed. Hopefully these changes improve the overall usability of the bungee.
v2 has not been printed yet.
Parts to print:
MCH_v2_base.stl -- (100x100x~10*)mm; *legs 3mm, with ~10mm max for middle
MCH_v2_arm.stl -- (10x110x2.5)mm
Full Print:
MCH_v2_full.stl
MCH_v2.0.scad
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
