Mouse cable holder

Mouse cable holder that holds the cable, for easier gaming sessions and better cable management. It's an easy mounting with a screw that holds the body in place. I used this with a G502 mouse, so the cable clips is measured for that type of mouse. The table thickness is maximum 35.50mm.

All you need is a 608 bearing that rotate the arm.

The print took totally 14hours.
- I used 40% infill.
- Supports.
- Printed at 0.15 layer quality.
- 60mm/s

I found out that best printing positions for the body and the arm was on the side. The screw really doesn't matter. I printed it in a vertical position.