MakerWorld
Organizers
Zum Modell
Mouse Holder
40
Downloads
22
Likes
12
Makes
Sturdy mouse holder for underneath your desk. There is a hole to put a charger for your mouse through. Dimensions for the print are 12.1 x 16.2 x 6 cm (width x length x hight) and can hold a mouse up to 6.9 x 13.5 x 4.7 cm. Uses 184g of filament, I hope someone else can find this useful. This is my first attempt at 3d modelling so any feedback is greatly appreciated.You can attach the holder to the underside of your desk using screws or double sided tape as I did.Boost MeIf you can! :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
