Movable Control Panel Bracket For Ender3 V3 SE

1. This is a controller bracket that utilizes a ball end so that it can be freely adjusted in various directions.2. a. Printing involves two cap models. b. The PanelSide L R model prints in one of the two convenient directions. c. The remaining models are printed one at a time.3. For the Control Panel Holder PrintSide model, slice it by rotating it 180 degrees as shown in the example.4. Assembly is not difficult. You can assemble and use them in order.FixesThere were reports that the cable was too short and did not provide sufficient drive when the above model was printed as is. So, I modified the model.I remodeled it into a shape that combines the Control Panel Holder PrinterSide model and the Connecting Rod model.The new combination goes like this.Control Panel Bracket, Holder Rod Cap, Control Pannel Holder PrinterSide 1stage type, Control Panel Holder PannelSide R or LYou can print it like this, and if the existing print is too short and difficult to use, you can just insert one Control Pannel Holder PrinterSide 1stage type.