Moxon Vise assembly kit

This is a simple old skool Moxon vise kit for metric M16 threaded rods and nuts.

I printed the parts with the following Cura settings on my Ender 3:
- Layer height: 0.2
- Shell: Wall line count: 4 (important!, these parts need to be sturdy)
- Infill density: 65%
- Build plate adhesion: Brim
- Supports: YES
- Material: PLA
- When printing the washers you don't need a brim and you should set the infill to 100%

You need:
- Two M16 metric threaded rods. Approx 20-30 cm long.
- Six M16 metric nuts
- Two identical wooden blocks (one front and one backing block) for you vise. Preferably some kind of hardwood.

Instructions:
- Glue one M16 nut to to each of the Vise Handles. I prefer epoxy glue for this task.
- Drill two 16mm holes (left and right) through both blocks while perfectly aligned. Approx 30 mm from each side perfectly centered.
- Enlarge the holes on the front block in the horisontal direction, you are gonna need the wiggle room. Do not enlarge it in the vertic