Thingiverse
MP Mini Delta filament guide
von tedder
151
Downloads
102
Likes
3
Makes
I wanted to use filament that was hanging from my walls, rather than from the Delta, but I was worried about it entering in weird angles. So, this.
No support needed, just print it in the given orientation.
No support needed, just print it in the given orientation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
