MP Select Mini V2 Feeder for Flex TPU

This is still a work in progress; however it is functional.

MP Select Mini V2 Feeder Base plate, Arm, Cover, and Guide/Spacer.

Be sure to print all the pieces separately and flat.

You will need a couple shorter screws however all the other stock hardware should work.

How is this different than the V1?
The spring was too lose on the V1 version so it was compressed a bit more. If the spring is too loose feeding will stop and prints will be thin.
The pin for the bearing was added
The screw holes were resized to not need additional hardware.

The feeder guide is needed as a spacer for the stock long screws, and helps. It was made to swing over the arm.

The pin to clamp in the bowden tube connector still needs work. It does not fully fit yet. The V1 uses a bolt, V2 uses pressure fit. It should fit in there and hold; however without the clip it will eventually push out.



This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8JHpy9SO4Ru