Thingiverse
MPCNC Filament Spool Holder
by nppc
10
Downloads
2
Likes
0
Makes
Filament Spool holder for MPCNC with easy release clamp.
The Filament Spool should be above the Machine. It can be fixed to the edge of the table.
The threaded rod is 8mm in diameter and about 15cm long.
2 Bearings are something like 608-2RS 608 RS (8x22x7).
The pipe diameter is 15mm, but I included OpenSCAD file for customizing it.
Variables:
Pipe_D - is the diameter of pipe.
Holder_Height - height of the base part
PART - what part to print (0-4).
If you find that clamp is too tight, you can make it warn (in case of PLA) and stretch a bit.
09.03.17
Also made a simplified top part, without a clamp.
The Filament Spool should be above the Machine. It can be fixed to the edge of the table.
The threaded rod is 8mm in diameter and about 15cm long.
2 Bearings are something like 608-2RS 608 RS (8x22x7).
The pipe diameter is 15mm, but I included OpenSCAD file for customizing it.
Variables:
Pipe_D - is the diameter of pipe.
Holder_Height - height of the base part
PART - what part to print (0-4).
If you find that clamp is too tight, you can make it warn (in case of PLA) and stretch a bit.
09.03.17
Also made a simplified top part, without a clamp.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
