Thingiverse
MPCNC Flex Foot Remix
von voglster
22
Downloads
7
Likes
0
Makes
updated 3/17/2016
lower the width a bit and changed the sizes of the nut holders on the bottom to better fit the home depot nuts I have... Could be a tight fit so be ready to heat up the nuts a bit to push em in.
Slight modification to shrink the nut trap a bit (nylock nuts were spinning in mine) and added nut support all around the nut.
line 235-241 is all.
lower the width a bit and changed the sizes of the nut holders on the bottom to better fit the home depot nuts I have... Could be a tight fit so be ready to heat up the nuts a bit to push em in.
Slight modification to shrink the nut trap a bit (nylock nuts were spinning in mine) and added nut support all around the nut.
line 235-241 is all.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
