MPCNC LCD Leg Mount

This is a remix of the LCD controller mount for the MPCNC made by Alted. Actually just the clip. I wanted a mount for the LCD controller since I kept snagging the wires when moving between operations. I figure it would be best to keep it one place.

I knew I didn't want it to be permanent or right in front of the work area I had, so I came up with a way to mount it to one of the corner legs. I was not sure of the display angle so I made it a bit adjustable. It also had to be stiff enough to handle the button presses and all too frequent emergency resets! Since it is on the leg, it can swivel it out of the way if I need it too. It can still be taken off and used by hand if needed though. I also beefed up the clip thickness some as the original clip did not grip my controller that snugly.

I hate printing with supports so maybe these can be printed without any. However, I printed the mounts with supports just to make sure I got the nut traps right. The clips don't