Thingiverse
mpCNC miniXT
by pavel569
166
Downloads
99
Likes
0
Makes
Customized MPCNC designed by Alted, miniXT - small working area & extra tall. I need a machine that will be able to print and laser engrave and will fit my work table. Also, the storage is an issue so I wanted it to be hoisted under the ceiling. All the electronics is mounted on the middle horizontal tube or tubes.
The support tubes are 1/2" electrical conduit (18mm OD)
Hardware is standard for the original MPCNC, 6-32 screws and nuts or small wood screws (mainly for some clamps).
Parts:
midd stiff ...... rev.B: These have to be installed while assembling the frame. They slide on the corner tubes.
midd stiff ......: Can be added to a current frame. Each part consist of two halves - inner & outer. Please note that these has not been tested, I use the permanent version above.
corner lock block: to square frame easily. Mark centers of the corner tubes and drill the holes in your baseplate. Screw puck in each and slide the tubes over. They'
The support tubes are 1/2" electrical conduit (18mm OD)
Hardware is standard for the original MPCNC, 6-32 screws and nuts or small wood screws (mainly for some clamps).
Parts:
midd stiff ...... rev.B: These have to be installed while assembling the frame. They slide on the corner tubes.
midd stiff ......: Can be added to a current frame. Each part consist of two halves - inner & outer. Please note that these has not been tested, I use the permanent version above.
corner lock block: to square frame easily. Mark centers of the corner tubes and drill the holes in your baseplate. Screw puck in each and slide the tubes over. They'
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!