MPCNC Nema 17 Angle Mount

I'm using 1in aluminum angle to support the Z-axis cable chain on my MPCNC build. Most of the cable chain parts came from thing:2301104 but the angle mount on the original is sized for NEMA 23 steppers instead of the more common NEMA 17s.

This is a remix of two parts mashed together in Tinkercad to enable the 1in aluminum angle to be used with NEMA 17 steppers.

Mirror the STL to make the opposite end.

3/17/2019 Added an offset version as the initial one didn't fit my setup too well (was too close to the gantry).