Thingiverse
Tools
Go to Model
MPCNC Primo Drag Chain
312
Downloads
187
Likes
1
Makes
This group of parts implements __Cable Management Drag Chains__ on **V1 Engineering MPCNC Primo** model. Drag Chains for all three axises are supported.
The following hardware is used:
- 5ea M3x12 Counter Sunk Flat Head machine screws and lock nuts (Cable Chain Wood strip to Mount & Middle Z Axis Drag Chain to Wood strip)
- 6ea M3 Counter Sunk Flat Head Wood Screws to mount Drag Chain to Table Bed. (2 at terminating end and one in the middle of X & Y Drag Chains.
Note: The Gantry Tube must be longer that the V1 Engineering calculator provides for. As a rule of thumb the Grantry Tube length should be the same as the X/Y Rail lengths or 2.5" longer than the calculator indicates, which ever results in the longest tubes. For X/Y rails of 36" in length, the Grantry rails should also be 35.5 to 36" in length.
The following hardware is used:
- 5ea M3x12 Counter Sunk Flat Head machine screws and lock nuts (Cable Chain Wood strip to Mount & Middle Z Axis Drag Chain to Wood strip)
- 6ea M3 Counter Sunk Flat Head Wood Screws to mount Drag Chain to Table Bed. (2 at terminating end and one in the middle of X & Y Drag Chains.
Note: The Gantry Tube must be longer that the V1 Engineering calculator provides for. As a rule of thumb the Grantry Tube length should be the same as the X/Y Rail lengths or 2.5" longer than the calculator indicates, which ever results in the longest tubes. For X/Y rails of 36" in length, the Grantry rails should also be 35.5 to 36" in length.
jmillerfo also publishes on
31 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
