MPCNC Z Axis Cable Raceway

This is a simple set of brackets designed to bolt on to the Y-axis stepper motors, enclosing a 1/16"x1" piece of angle aluminum. You can then either lay a cable chain in the channel, or use the included printable clamp to secure your Z-axis wiring out of the way. All pieces print with no support, I use 3 perimeters and 55% infill, though none of the pieces have significant amounts of infill.

In addition to the printed parts, you will need:

* A piece of 1/16" x 1" angle aluminum slightly shorter than your Y axis
* 8 M3 x 10mm bolts (these replace the stock stepper motor bolts which are too short to clear the brackets and stock parts