MPCNC Z Rail Nut traps

Made some new ZRail Nut Traps, with the possibility to mount things inside!

For example small line/cross laser modules, endoskope usb cameras, height sensors, LED lights, pipes for compressed air or whatever you come up with... (write in the comments ;)

There are three versions:
- middle version is the most original one - you can just replace it,
- long version has an additional mounting point above (mounting my Suhner spindle with the original one was very unstable...)
- short version for mounting short things, like laser modules... ;)

The big mounting holes are at 22,5/97,5 and 132,5mm from the bottom.
The small setscrew holes at 20/95/ and 130mm (at a 120 degree angle).

The Nuts will be directly behind the wall of the rail - had no problem with that so far. Just make shure, that the screws are short enough and do not protrude into the mounting hole.

Cheers
Raphael