Thingiverse
MpLab Snap Case
von goarray
1
Downloads
1
Likes
0
Makes
Slim (7mm) snap together case for the MpLab Snap microcontroller programmer/debugger.
Note: Due to manufacturing differences, the pads on the bottom of your snap may not align with the holed in the case. You can remove the pads or move the holes using either the attached *.f3d or *.obj file.
Recommend printing a draft and making needed adjustments.
Note: Due to manufacturing differences, the pads on the bottom of your snap may not align with the holed in the case. You can remove the pads or move the holes using either the attached *.f3d or *.obj file.
Recommend printing a draft and making needed adjustments.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
