MPMD LED Trash shield

This is a remix of pipefitter72's "[MPMD belt shield](https://www.thingiverse.com/thing:3374886)". It uses three (3) 5mm LEDs connected in parallel with the electronics fan. A Y-splitter was made so that I could wire these into the electronics fan on the controller board, so they're always on with the printer.

You have the option for the LED to be angled up (+15 degrees), down (-15 degrees), or parallel to the bed.

I highly recommend using the "-15" version for the tower opposite of the screen as that will aim downwards toward the bed instead of at your face. Aside from that, aim the other two as you please.

I used wire cutters, wire strippers, PA-09 crimpers, [JST XH 2.54mm connectors](https://www.aliexpress.us/item/2255799957794109.html) (this comes with both male and female connections), [5mm LEDs](https://www.amazon.com/dp/B08G4X23BR)(you can use anything similar as long as it's a 12v 5mm LED with appropriate resistor), extra wire, heat shrink tubing or electrical tape, an