MPSM Bed Cable Chain NO DRILL

Yup, remixing my own remixes again.

This is an adaptor to run my bed cable chain *without drilling*. It will lift your printer about 2mm. You shouldn't need longer wires or longer screws, but I do recommend using more links than the drill version.

Currently only available for the middle of the bed mount: https://www.thingiverse.com/thing:2198351

Chain link (I recommend 10): https://www.thingiverse.com/thing:1167746

Excuse the single crappy picture, I will have more once I get everything all buttoned up in the next few days.

You'll need to print one chain piece and three blank pieces. Just for the hell of it, I've uploaded my MPSM gcode file to print all 4 together.

*Edit: It was pointed out to me that this offsets the USB and SD card ports in the side panel, so I included washers that are the same thickness as the lift to raise the board up.. These are not included in the gcode file.