Thingiverse
Mr. Hairy Muttonchop
di ModernGnome
14
Download
23
Likes
0
Makes
**Beardo #1: Mr. Muttonchop**
Loosely inspired by Hairy Lion and the Chia Pets (cool band name!), I modeled this figure in the preview version of Adobe Fuse, then added the hair using Microsoft 3D Builder. It uses modified sections of The Furry Vase (http://www.thingiverse.com/thing:1800503) to simulate hair without requiring the "sacrificial" exterior cylinder used on the Hairy Lion (http://www.thingiverse.com/thing:2007221).
**Instructions:** Print *without* support. (The hair is not supposed to print "perfectly.") The two pictures show the printed results with and without styling the "hair" with a heat gun. I used 0% infill, 2 shells, 0.2 layer height, no raft, no support. Printed with Seacans Gold PLA at 205C.
**Note:** I've increased the amount of "beard" since the sample model was printed. Leave a comment if you'd like to see more "Beardo" figures. Have fun!
**Tools:** Adobe Fuse, Meshmixer, 3D Builder, NetFabb
Loosely inspired by Hairy Lion and the Chia Pets (cool band name!), I modeled this figure in the preview version of Adobe Fuse, then added the hair using Microsoft 3D Builder. It uses modified sections of The Furry Vase (http://www.thingiverse.com/thing:1800503) to simulate hair without requiring the "sacrificial" exterior cylinder used on the Hairy Lion (http://www.thingiverse.com/thing:2007221).
**Instructions:** Print *without* support. (The hair is not supposed to print "perfectly.") The two pictures show the printed results with and without styling the "hair" with a heat gun. I used 0% infill, 2 shells, 0.2 layer height, no raft, no support. Printed with Seacans Gold PLA at 205C.
**Note:** I've increased the amount of "beard" since the sample model was printed. Leave a comment if you'd like to see more "Beardo" figures. Have fun!
**Tools:** Adobe Fuse, Meshmixer, 3D Builder, NetFabb
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
