MR60 Panel Mount Connector

Amass-style MR60 panel mount connector that I printed and used on my esk8 enclosure for my phase wires. I printed mine out of PETG, use your own material at your own discretion. I through-bolted using M4 hardware and the gasket which I printed from TPU. You will need to remove the 4mm bullet connectors from an existing MR60 connector (male) and epoxy them in place in the new panel mount. Plug a female side in to hold your bullets in place and epoxy. You are better off soldering the bullets onto your wires before epoxying so you don't subject your printed panel mount to the heat of soldering.