MSP430 Launchpad Case

Two piece small clean enclosure for MSP430 Launchpad. Green and Red LED's on launchpad are visible with enclosure cover on and there are two holes in the top cover allowing the push buttons to be accessed. Female header pins on underside of launchpad are exposed in the lower part of the enclosure and fit flush to the bottom surface.

Prints great with almost any settings and works great as a small and lightweight case to protect your MCU.

Top cover is attached with 4x - M3x0.5mmx8mm socket cap bolts that thread into M3x0.5mmx3.8mm heat set inserts installed in lower part of enclosure. Part numbers have been included below.

McMaster-Carr Part No's.
4x - M3x0.5mmx8mm socket cap bolts - 92290A113
4x - M3x0.5mmx3.8mm heat set inserts - 94180A331


Check us out at www.mattertec3d.com for all your 3d printing needs.

You can also check out our similar enclosure design for an Arduino Leonardo here:
http://www.thingiverse.com/thing:1441657