MT2 Collet Wall Holders

MT2 wall mount Collet holders
Someone asked if i could make a MT2 version of the R8 collet holder wall mounts, i don't own any MT2 collets, but i have a couple of MT2 bits for my mini lathe, so i modeled these using the (manky) dead centre i have.

The hole is the proper MT2 taper (1.4307 degrees) and these should hold the collets in a good position, with enough sticking out to grab hold of (can always push them up from underneath too)

I made them with the text 1mm to 12mm, and i've included a blank one that you can put stickers on if you use that weird imperial measurement system :)

Also made one with no mounting holes in the back, so if you are mounting them on pegboard you can drill holes to match, and use a label printer to make text stickers for the sizes.




The holders interlock with other ones i have made, and are based on these ER32 collet holders :
https://www.thingiverse.com/thing:3588076


The screws i use to mount these to the wall are called 'Flange He