Thingiverse

MT2 Lathe Pen Press Insert

von jimustanguitar

197 Downloads

101 Likes

2 Makes

I designed these inserts to fit an MT2 morse taper on my lathe, and to act as jaws or pads for a pen press. The idea is to use your tailstock as the press.

The insert has a female cone to fit the tip of a pen. The female taper for the pen tip is only 5mm, so it can be used as a flat jaw as well (because it's smaller than 7mm).

Drawn in DesignSpark Mechanical - RSDOC source is included.

Designspark DSM dsm2 lathe pen lathe pen press morse taper morse taper 2 MT2 pen press pen turning rsdoc taper taper 2 TheMakerhive Designspark DSM dsm2 lathe pen lathe pen press morse taper morse taper 2 MT2 pen press pen turning rsdoc taper taper 2 TheMakerhive

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat