Thingiverse
MTB lamp holder
von Sparatutto
7
Downloads
5
Likes
0
Makes
My low cost lamp is very good but the holder system is not very good.
It is based to a rubber band and it is not strong enough especially over the terrain trails.
I did design this holder to keep it in a more firm position.
You can use two (one for each side) if you prefer.
It can be used for battery bank too.
If you like and want to donate I'm happy and I will buy PLA for more experiments! :-)
https://paypal.me/ivobinda
It is based to a rubber band and it is not strong enough especially over the terrain trails.
I did design this holder to keep it in a more firm position.
You can use two (one for each side) if you prefer.
It can be used for battery bank too.
If you like and want to donate I'm happy and I will buy PLA for more experiments! :-)
https://paypal.me/ivobinda
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
