Thingiverse
MTB Mudguard like MarshGuard
by suxfevi
28
Downloads
24
Likes
0
Makes
I found some mudguards online, but they were smaller than the original MarshGuard and didn't fit my fork. So I wanted to make one that would fit proper MTB forks (like Fox and Rockshox)
I copied the identical shape of the MarshGuard that I use on all my bikes. Unfortuanately it didn't fit on the bed of my Ender 5...so I had to reduce the size to 93% to make it fit. But even at 93% of the original one, it fits perfectly the bike.
If you have a bed larger than the Ener 5 (larger than 220x220) you can increase the size by about 7% to get the size identical to the original MarshGuard
Priting tips:
1) Make it 3-4 layers thick
2) Use PETG. PLA is stiff and will crack, while PETG is very flexible and more impact resistant too.
I copied the identical shape of the MarshGuard that I use on all my bikes. Unfortuanately it didn't fit on the bed of my Ender 5...so I had to reduce the size to 93% to make it fit. But even at 93% of the original one, it fits perfectly the bike.
If you have a bed larger than the Ener 5 (larger than 220x220) you can increase the size by about 7% to get the size identical to the original MarshGuard
Priting tips:
1) Make it 3-4 layers thick
2) Use PETG. PLA is stiff and will crack, while PETG is very flexible and more impact resistant too.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
