Thingiverse
MTB Torque Cap Adapter
von Christoph_Witte
25
Downloads
17
Likes
0
Makes
This thingy will guide the front hub (normal diameter, ~22 mm) in the proper position in a Rockshox Torque Cap fork (cutout diameter ~31 mm) so the axle slips in easily.
Two prints of the thing required, one on either side. I just glued them into place.
Two prints of the thing required, one on either side. I just glued them into place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!