Slicer Discord
MTE's LED Reservoir Ring – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

MTE's LED Reservoir Ring

1 Téléchargements
1 Likes
0 Makes
Voir le modèle
This is a DIY LED Ring for water cooling reservoirsCompatibility:The LED Ring is designed for standard 60mm diameter water tanks with any height. It fits for example onto the Alphacool Eisbecher or the EK Waterblocks RES X3. The LED strip with its clear rubber coating will clamp onto the tube and will not move. It will also not scratch your reservoir, because the printed part doesn't touch it directly, if done correctly. What you are going to need:LED Strip (≥10cm)Soldering ironLED connector or molex connectorInstructions:Just print the file in the color of your choice, cut a LED Strip into a 100mm piece (in most cases one segment) and solder wires on to it. Then connect the soldered wires to the correct RGB hub on your Mainboard. You can also simply attach it to a single 12v cable from the power supply (molex, only one color e.g. R/G/B/W). [Do research on the correct wiring - I'm not responsible for any accidents]
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA, PETG, Polycarbonate
Plateau min.
50 mm (Petit)
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

Mastertryeffect publie également sur

4 modèles supplémentaires sur 1 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection