Slicer Discord
MTG Red Mana / Devotion Counter Double Sided – 3D-printbaar model van MakerWorld MakerWorld
Other Toys & Games

MTG Red Mana / Devotion Counter Double Sided

310 Downloads
60 Likes
259 Makes
Model downloaden
If you like this model and it's not too much trouble, please hit the πŸ‘ button - it helps out a lot πŸ˜€ This is a double sided Red Devotion / Mana (Mountain) counter for Magic the Gathering. It can be very handy for mono red decks running cards that care about Devotion such as (affiliate link) Nykthos, Shrine to Nyx or for when you start generating mana. It is 3 separate parts: a top, a bottom and a dial in the middle. There is also an included box that can hold 27x total counters (9x total slots with each slot holding 3x counters). For the counter itself:The front side's dial goes from 1 to 10The back side's dial goes from 11 to 20Additional HardwareThe box and lid require (affiliate link) 12x magnets (4mm x 2mm). These are the exact magnets I used, but I've also linked the same sized magnets from Bambu Lab's store below in the Bill of Materials section. The counter itself does not require any additional hardware.Boost MeShow your support by boosting this model. Any
Categorie
Other Toys & Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
3-delige montage
Hardware nodig
Supports 1/3
Montage 1/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

TheMakerSphere publiceert ook op

26 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

4 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord β˜• Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie