Slicer Discord
MTG "Tattoo case" 12-16 deck storage case inserts – 3D-Druckmodell von MakerWorld MakerWorld
Board Games

MTG "Tattoo case" 12-16 deck storage case inserts

5 Downloads
3 Likes
1 Makes
Zum Modell
These inserts have been quite popular among our Magic The Gathering playgroup. They are meant to fit “tattoo cases” which can be bought from Amazon for relatively cheap. The case typically holds up 16 regular 60-cards sleeved decks, or 12 edh 100-cards sleeved decks, or a 720 card cube & lands.Each deck slot is separated by a 12mm label holder, which also makes picking up a deck easier.You will want to buy a case that is 12.6" x 9.5" x 5.1" in size. If using any of the links below, please double check that the listing specify the correct size. Someone in our playgroup bought a case by using visual pictures only and the inserts did not fit, be careful. Most of these cases will come with cardboard separators. Use a heat gun to melt the glue or a knife to remove. https://amzn.to/4nCNgOIhttps://amzn.to/3TNOU2Fhttps://amzn.to/4eMFk9Shttps://amzn.to/4ktv8V0https://amzn.to/4lnn8Gmhttps://amzn.to/3TvJ7OWhttps://amzn.to/4kqKw4chttps://amzn.to/46w7xzr
Kategorie
Board Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

8bitmcu veröffentlicht auch auf

57 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen