Much Larger Stackable Drawer Still Vase mode Compatible

Update 2022-0307

I don't like the angle of the front of the drawer seems to print "thin" my print failed as it reached this the PLA dug a channel in the feeder and created enough friction that the stepper could not overcome.

I remodeled some aspects and cleans up some parts of the model and updated all the files. delete what you have an redownload. same names for all files

--------------------------------------------------------

I had to do some alterations and hacking. removing little bits here that break vase mode etc.. (curved top surfaces pointed convergences) and since its so much larger I added reinforcement "ribs" throughout as well as some external ribs inside for that rear angled surface which was "dicey" for vase mode. the ribs will help with that.

the bottom is thick 2mm thick so 5 layers at 0.4mm. I have included gcode for PLA and 200x200 and 300x300 platens where its open honeycomb bottom layers and just 2 solid layers (less plastic less slop and less print