Muha Tricopter

Print Instructions 1. Print the file named BODY Upward, so that the flat part is on the bed. 2. Print a file named Pin 4 times. This file will be printed while lying down, not while standing. 3. Print a file named Servo arm With supports so that the part on which the engine sits is facing up 4. Then print a file named battery holder Twice, regardless of the printing direction. Assembly instructions: 1. Insert the pins into the body while standing and stick them with a drop of glue. 2. Paste the Battery holder innder the servo 3. First you insert the servo from above, then the board on top of it, then you solder the motors. Betaflight instructions: 1. Switch to tricopter mode in the settings. 2. The rest of the settings are like a regular drone. 3. PID Very low - P In all 18, I In all 9 D zero Use YouTube to search for information about Tricopter and its settings. Good luck!