Multi bar percussion clamp

Made a clamp to hold two crotales up on a 3/8" rod. Added a few extra holes for versatility. The clamping bolts are 3/8" with hex heads - I use wing nuts and washers on the other side. There is no post processing required there.
The rod holes are for 3/8" rods, but you could remix it using Tinkercad to whatever size you want. The horizontal holes are meant to be tapped with a 1/4-20 tap and thumb bolts used. I reamed the holes to 3/8" in the end as they were a tad undersized.

I recommend 45%+ infill, 1.6mm wall thickness.

This clamp was inspired by a few other designs here on Thingiverse.