Multi brand coaster set

Print out a set of your favorite brand of coasters. There are 16 different designs to choose from, and 2 coaster holders modeled to look like a shell casing. The short one holds up to 6 coasters and the tall one up to 12. Coasters are 88mm in diameter or approximately 3.5" Printing tips and trouble shooting: I’ve tried multiple build plates, and in my opinion, a textured PEI plate is the one to use. Print the model so it is in the face down position. Clean your build plate before printing! The first layer is critical. There are some small and intricate designs on a few of these and if the first layer doesn’t adhere, you’re going to get bad results. I would recommend you take a quick look at the print after the first layer is done. If you see imperfections that you’re not happy with, stop the print and try it again. Make sure your filament is dry! Make sure your printer is not under or over extruding. If you’re getting gaps in the first layer, a quick calibration might be required.