Multi Cable Holder - Customizable

A cable holder for different sized cables, fully customizable.

In OpenSCAD you can customize the amount of slots, how they are arranged, the length of the pegs and if you want screw holes.

PLEASE READ CAREFULLY:
This holder stresses PLA quite much, so please follow these instructions:
* Print with 100% infill or 3mm wall and top/bottom thickness (making sure it is a solid print) and 0.4mm layer height
* Print with PLA you know is not brittle, most white or black PLA's should work
* When screwing it on don't use machine tools, just screw it far enough so it doesn't flap around (otherwise the PLA might break), use Spax screws
* If you are paranoid you can use double sided tape and screws at the same time