Multi-tool holder V 1.3

So this is my first try at a creating a belt case for my Gerber Suspension. I am only now printing it out. So be patient not sure how it is going to work. First time I have even designed anything on Fusion 360.

So I have gone back and edited the design it now hows dimensions I feel will work better. Although I kept the belt hanger the same thickness I have increased the width to make it sturdier and the belt area by 1MM for the thicker possible belts. The interior dimensions were off by 5MM, making it a tight fit. I have increase it accordingly so that it should be tight enough for a snug fit but with out being over-tight.

This is best printed vertically.

So now I have printed this out and the measurements are spot on. I will try to develop a stronger belt loop in the future but it will require field testing for now.

So I have gone back and changed a few tings I took away the bottom cut out and just widened the slot because my finger would not fit in the small section.