Slicer Discord
Multibin 1H 30-Degree Lite Multirail Interface – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

Multibin 1H 30-Degree Lite Multirail Interface

24 Downloads
19 Likes
5 Makes
Zum Modell
A Lite Multirail interface for attaching 1H-height Multibins, etc., at a 30-degree angle to a Multiboard. Accessories with Lite Multirails will snap into place for a secure hold.Print using standard Multiboard settings (0.2 mm layer height, 3 walls, 15% Gyroid infill). I recommend using tree supports if you want a smooth surface on the back plate. Will print fine without but will show stringing patterns on the non-functional surface. This design is printed under the Multiboard/MultiBuild License.
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Mittlere Konfidenz
Warum?
0.20mm Schichten
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Schichthöhe
0.2 mm
Ca. Druckzeit
1 h
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

SorenTheSwede veröffentlicht auch auf

65 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen