MakerWorld
Organizers
Go to Model
multiboard - 46mm can holder
10
Downloads
4
Likes
4
Makes
This holder for small 46mm cans was created for multiboard.io mounts. It gets fixed with a single Small Thread Point Bolt, below the mount is a small nipple which avoids that the holder is able to rotate, this way only a single bolt is needed. I prefer to print the holder with support, but it prints also well without. Needed Thread Point Bolt - Folded Version:https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Folded%29-1123334 Thread Point Bolt - alternative Version with Support:https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Supported%29-1470815
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
