Thingiverse

Multiboard 8mm Dual Offset Snap (DS Part A) Inside Corner Bracket

von Skater_j10

3 Downloads

11 Likes

0 Makes

I simply used TinkerCAD to merge 2 x Multiboard 8mm Dual Offset Snaps (DS Part A) pieces from Keep Making on Thangs:

https://thangs.com/designer/Multiboard/3d-model/8%20mm%20-%20Dual%20Offset%20Snap%20%28DS%20Part%20A%29%20-%20x4%20Stack-974384?srsltid=AfmBOoohy97s55KzHPO-HYBHKmzGNqiWxgGl4HsnzBGeAydQ45H7ixlB

See a video about this bracket in practical use on my TikTok Botmatrix Page: https://www.tiktok.com/@botmatrix/video/7414080753429941509?lang=en

I am perpetuating the same license as the Push-Fit connectors that I remixed from, the full license is here: https://www.multiboard.io/license

cable organization Desk Organization Garage organization keepmaking kitchen organization multiboard Multiboard accessory multiboard bracket multiboard compatible multiboardremix office organization organization tool organization workshop organization

Quelle

Thingiverse

Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz

Warum?

20-teiliger Zusammenbau

20 Teile zum Zusammenbau

Supports 1/3

Zusammenbau 3/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker