Multiboard Hobby Brush Holder v04

This is my 4th iteration of a brush holder to add to my multiboard at my paint station. I've acquired a fairly large number of brushes and I like them to be out and visible so I can select the appropriate brush quickly. In this version I enlarged the unit to hold 40 brushes (4 rows of 10). I also added a 20 degree slope so provide better visibility to the rear brushes. This is printed in PLA Basic Red, but you can use your choice of filament, just be sure to adjust your filament settings based on your choice. It is held to the multiboard through 2 push pin brackets (included) that slide into the unit from the front. You just need to have snaps in the multiboard where these pins will be inserted (snap files not included). For best print quality print this on on of the short sides, I have enabled critical supports, you can adjust based on your preferences. p.s. I clearly should have dried this PLA before printing, but since it is for my own use I was not going to stress about it.